The first time I changed the oil in my 1991 Mazda Miata, I spent more time cleaning the driveway than I spent under the car. The drain plug came out hot and sideways, the stream walked right off the edge of my pan, and I spent the next twenty minutes pushing kitty litter around with the toe of my shoe.
That was a long time ago and I have gotten better at it. Better never meant clean, though. My garage is a one-and-a-half-car space with a rolling tool chest and a workbench along the back wall, and that sealed concrete floor kept a record of every oil change I had ever done. I used to lay cardboard down first, like a confession.
The 2012 Toyota Tacoma did not make it easier. You would think the extra height helps and it does not. There is a skid plate in the way, the drain plug aims straight at a crossmember, and the oil comes out with enough enthusiasm to find the one gap in your drain pan. I have a shirt in the rag bin that proves it.
So when I tell you I did not buy the EWK 6.5L Pneumatic/Manual Oil Extractor because I wanted another gadget, that is the truth. I bought it because I was tired of the floor. The idea is simple. You pull the oil out through the dipstick tube instead of draining it out the bottom, so there is no jack, no jack stands, no crawling, and no stream of hot oil looking for your sleeve.
It took me two oil changes before I fully trusted it, and the first one I ran with the drain pan underneath, just in case. Now it sits on the shelf above the workbench, and the drain pan hangs on a nail where I can see it and mostly ignore it.
The Tacoma gave up everything through the dipstick tube and I never put a wrench on the drain plug.
Change the Oil Without Lifting the Car
The EWK extractor pulls oil up through the dipstick tube, so the only thing you open is the hood. Manual pump when you are working outside, air-powered when you want shop speed.
Amazon Check Today's Price on Amazon →Here is the actual routine. I warm the engine for five or six minutes, then shut it off and let it sit while I get set up. Warm oil moves faster and that matters more than most people think. Then I pull the dipstick, feed one of the two extended suction tubes down the tube until it reaches the bottom of the pan, and connect the other end.
Manual mode is a pump handle and it works fine. I use that when I do not feel like dragging the compressor out to the driveway. Pneumatic mode is the one I reach for on the Tacoma. You hook up air, the extractor runs anywhere from 40 to 170 PSI, and the pan comes up in a few minutes instead of the twenty I used to lose to draining and wiping.
The thing I check every single time is volume. If the engine is supposed to hold a certain amount and I pull out noticeably less, something is wrong and I want to know that before I pour new oil in. Two tubes come with the kit and I use a different one on each car, depending on how the dipstick tube bends. When the flow stops I give it another minute, then pull the tube, and it comes out clean instead of dripping down the side of the engine.
The reservoir holds 6.5 liters, which is more than either of my cars needs, so I am not stopping halfway to empty it. The body is translucent, so I can watch the level climb and see the color of what is coming out, which tells me plenty. It stands about 22 inches tall and weighs a little over six pounds empty, so it stores on a shelf without me rearranging the garage.
Two things I will not pretend away. First, it pulls oil, not sediment. If your pan has sludge sitting in the bottom, a drain plug still flushes that better and there is no way around it. Second, EWK lists this one as not compatible with the Mercedes W212 E350 or the C218 CLS 350, and you should not use it on gasoline or other highly volatile fluids. Read the listing before you buy instead of after.
What changed for me is smaller than a before and after photo would suggest and bigger than I expected. I stopped buying crush washers. I stopped checking a drain plug torque spec I could never remember. The Miata gets its oil changed on a Tuesday night now, in about the time it takes to get dinner going, and the floor stays sealed concrete.
What I'd Tell You If We Were Sitting at My Kitchen Table
I would tell you to warm the engine but not to get it hot, because hot oil through a plastic tube is a bad trade for five minutes of your time. I would tell you to keep the reservoir under the 6.5 liter mark, because overfilling turns a clean job into a mop job. I would tell you to pour the used oil back into the jugs your new oil came in and take it to the county recycling center, which is what I do, and to keep a rag and a funnel within arm's reach. And I would tell you the thing my dad told me when I was sixteen: the tool does not make you careful. If you still have to go under the car for a filter or a grease fitting, the jack stands go in before your shoulder does. The EWK extractor just means fewer of those trips.
The Tool That Got Me Off the Floor
If your back and your driveway have both had enough, this is the extractor I keep on my own shelf, and I would buy it again.
Amazon See It on Amazon →